It would help if you had a drain roughed in, with the pipe protruding out a few inches above the floor. Remove the bolts that hold the pipe rough-in and drain in place on the concrete floor. To loosen the screws, use a wrench set to determine the correct wrench size. Remove the bolts to separate the drain cover from the flange and the actual drain attachment by removing the top of the drain, also known as the drain cover.
Apply pressure to the drain flange with a screwdriver and turn it in either direction until the pipe cement bond is broken. To apply leverage, place the screwdriver in the old bolt holes from the flange.
The old drain should be removed from the stack. Use the No-Caulk Shower Drain, which is a leakproof shower drain assembly. You can get the No-caulk from any home improvement store and plumbing supply store. Drain pipes with more minor diameters are recommended for shower drainage.
This could be the case in construction projects when a shower tray is installed. To start the installation, connect the shower drain to the drainpipe and ensure that the drainage pipe has a good curve. Because the plug provides enough binding, it is not necessary to roll the drainage into the connection.
Return the shower bay and basket assembly to their original positions above the pipe. You may need to use a hammer and a small piece of wood to tap this gasket into place. To install the shower, drain cover, loosen the bolts on the flange, slide it over the top of the bolts, and turn it until it is locked in place. To complete the repair, tighten the bolts with a wrench.
While you stir up some concrete mix in a bucket until you have a thick, chunky slurry, cover the top of the drain with duct tape to preserve it. Mixing is done with a margin trowel. When tiling, make sure to incorporate a two-percent slope into the water drainage system.
Next, attach the drain body through the shower base and place the base on the concrete, so the drain body goes into the drain pipe. You can hire someone to saw a trench in the concrete floor from where the drain will be to where the drain pipe will exit the building. First, link the linear shower drain to the drainpipe and ensure an appropriate curve in the drainage pipe. Roll the drainage into the connection, because as. How to prep a shower for tile with schluter kerdi schluter kdh2 pvc fl kerdi drain h 2 inch schluter kerdi drain centre shower drains.
Please hit that like button and subscribe! Pin On Bath Re-do. Pin On Shower Drain. Your email address will not be published. About Contact Privacy Police. How to. Toggle Navigation. Share your thoughts Cancel reply Your email address will not be published. Just tap the caulking gasket in place using a hammer and a piece of wood.
Thread on and tighten the caulking nut to compress the gasket and to seal the pipe. You can use a slotted bar tool which comes with the assembly.
Just make sure that you have prepared a set of tools before doing this do-it-yourself project. The hand-tools that you can use to complete this project include a hammer, slip-joint pliers, hacksaw, and screwdriver with flat-blade tip. Contact Us Set Up the Drainage Line Fiberglass type of stall should work just fine in this type of setting.
Secure the Drainpipes for the Drain Assembly The drainpipes can exist about 2 inches in length above the concrete. Attach the Shower to the Drain Make sure that you have rolled out a coil of putty so that you can wrap it below the drainage basket flange.
The perforated drain cover should be snapped on after performing the previous instructions. For Emergency Service, please call Close Font Resize.
0コメント