Each tool sold separately includes eight patterns of copper mesh for systems with resolutions from 60 to mesh and 16 to 60 mesh respectively. Mesh values are labeled with lead for easy identification. A range of bar patterns within an acrylic cylinder allow for the visually observed limiting resolution to be easily converted into an effective focal spot size.
Anthropomorphic Neo-Natal Chest Phantom represents the transmission characteristics, histogram, physical size and structure of a kg neonate. Includes clinically relevant image quality challenges for resolution and noise in the form of a lung with simulated pneumothorax with pleural thickening, and a lung with simulated hyaline membrane disease. Diagnostic Product Solutions Brochure Favorite. Taking a mesh stainless steel printing net as an example, the wire diameter is 0.
Generally, the thickness of the mesh surface is twice as large as the wire diameter, but the mesh thickness is the same when the same mesh number and the same wire diameter, and the mesh thickness is relatively good because of the numerical value.
This is mainly used for stainless steel mesh with high mesh count and low wire diameter. Low mesh, large diameter stainless steel mesh is generally not suitable, it is best to measure the wire diameter directly. Finally, the wire diameter was measured indirectly by measuring the weight of the stainless steel mesh. This involves the measurement of the weight of the stainless steel mesh above, but in general the actual weight is a little lighter than the theoretical weight.
Therefore, this method is not accurate enough, but it is also a more effective detection method when the first two methods cannot be implemented.
Measurement of the number of meshes: There are generally special tools for the determination of meshes: density mirrors and eyepieces. The former generally has a higher number of measurements, while the latter has a lower number of measurements.
However, customers generally do not have these professional testing tools, and then use some simple methods to determine. For meshes with less than mesh, use a ruler, follow the warp, and count the number of meshes in 2. This value is the mesh. This method is less realistic for a mesh number greater than , and requires indirect detection by weight without a detection tool. Also use the above formula. Measurement of the net length of the net: the measuring tape can be used. The regular width is 1 meter and the length is 30 meters.
The width can be made up to 2 meters. The length can also be made according to customer requirements, usually 30 meters, but we still need to prevent individual manufacturers from deceiving customers by reducing the number of meters. Detection of stainless steel mesh material: The most important thing is to measure the content of NI, and then include Cr and C. The most accurate is to send to the testing agency.
Stainless steel can also be used to test the syrup test. Our stainless steel wire mesh inspection guarantees the purity of stainless steel materials mainly from feed testing and finished product inspection.
Generally, the finished product needs to be inspected at the initial, middle and end sections to ensure the material. There may be a misunderstanding here that the magnet can't hold the good material, and the magnetic one is bad.
0コメント